GB/T 12359-1990
Replaced
GB/T 15054.1-2018
Active
National standards
GB/T 15054.1-2018 Miniature screw threads—Part 1:Profiles,general plan and basic dimensions
GB/T 15054.1-2018 Miniature screw threads—Part 1:Profiles,general plan and basic dimensions
Basic Information
Standard Code:
GB/T 15054.1-2018
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Basic standards and general methods
ICS Name:
Special screw threads
Publish Date:
2018-05-14
Implement Date:
2018-10-01
Pages:
7 pages
Scope
This part of GB/T 15054 specifies the tooth profile, diameter, pitch series, and basic dimensions of small threads. This part is applicable to general-purpose small threads with a nominal diameter range of 0.3 mm to 1.4 mm. Note: The tooth profile and tolerances of small threads (S) with a nominal diameter range of 1 mm to 1.4 mm are different from those of ordinary threads (M).
Development Information
Same series standard
Replace the following standards
Referenced Standards
Related Standards
GB/T 7306.1-2000
Active
GB/T 7306.1-2000 Pipe threads with 55 degree thread angle where pressure-tight joints are made on the threads—Part 1:Parallel internal and taper external threads
GB/T 7306.2-2000
Active
GB/T 7306.2-2000 Pipe threads with 55 degree thread angle where pressure-tight joints are made on the threads—Part 2:Taper internal and external threads
GB/T 7307-2001
Active
GB/T 7307-2001 Pipe threads with 55 degree thread angle where pressure-tight joints are not made on the threads
GB/T 12716-2002
Replaced
GB/T 12716-2002 Pipe threads with the thread angle of 60 degrees where pressure-tight joints are made on the threads
GB/T 13576.1-2008
Active