GB/T 13540-1992
Replaced
GB/T 30123-2013
Active
National standards
GB/T 30123-2013 Busbar trunking systems(air insulation busbar)for wind power generation
GB/T 30123-2013 Busbar trunking systems(air insulation busbar)for wind power generation
Basic Information
Standard Code:
GB/T 30123-2013
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Low-voltage distribution electrical equipment
ICS Name:
Switching devices and controllers
Publish Date:
2013-12-17
Implement Date:
2014-06-14
Pages:
14 pages
Scope
This standard specifies the terms and definitions, technical requirements, test methods, inspection rules, nameplates, markings, packaging, transportation, and storage of air-type wind power generation conductive rail systems (hereinafter referred to as wind power bus ducts).
This standard applies to wind power bus ducts with a rated voltage of no more than 1,000 V AC and a frequency of 50 Hz or 60 Hz.
Development Information
Referenced Standards
GB/T 2423.10-2008 Environmental testing for electric and electronic products—Part 2:Tests methods Test Fc:Vibration(sinusoidal)
GB/T 4208-2008 Degrees of protection provided by enclosure(IP code)
GB 7251.1-2005 Low-voltage switchgear and control gear assemblies—Part 1:Type-tested and partially type-tested assemblies
GB 7251.2-2006 Low-voltage switchgear and controlgear assemblies—Part 2:Particular requirements for busbar trunking systems (busways)
JB/T 3085-1999 Product Packaging and Transportation Procedures for Power Transmission and Control Devices
Related Standards
GB/T 13601-1992
Replaced
GB/T 13601-1992 Operating tests under severe ice conditions for high-voltage switchgear
GB 7674-1997
Replaced
GB 7674-1997 Gas-insulated metal-enclosed switchgear for rated voltages of 72.5 kV and above
GB 7251.1-1997
Replaced
GB 7251.1-1997 Low-voltage switchgear and control gear assemblies—Part 1:Type-tested and partially type-tested assemblies
GB 7251.3-1997
Replaced
GB 7251.3-1997 Low-voltage switchgear and control gear assemblies—Part 3:Particular requirements for low-voltage switchgear and control gear assemblies intended to be installed in places where unskilled persons have access for their use—Distribution boards
GB 14048.7-1998
Replaced