GB/T 13633-1992
Replaced
DL/T 735-2023
Active
Industry standards-Electricity
DL/T 735-2023 The measurement and evaluation of dynamic characteristics of the stator winding end of large steam turbine generators
DL/T 735-2023 The measurement and evaluation of dynamic characteristics of the stator winding end of large steam turbine generators
Price:
$ 30
Basic Information
Standard Code:
DL/T 735-2023
Standard Type:
Industry standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Synchronous motor
ICS Name:
Generator
Publish Date:
2023-10-11
Implement Date:
2024-04-11
Scope
This document specifies the method and evaluation criteria for measuring the dynamic characteristics of the stator winding ends of steam turbine generators using the hammering method. This document is applicable to two-pole steam turbine generators with a rated power of 200MW and above, and a rated speed of 3000r/min and 3600r/min, and four-pole steam turbine generators with a speed of 1500r/min and 1800r/min. Steam turbine generators with a rated power of less than 200MW and synchronous condensers with a rated capacity of 300MVA and below can refer to this document for implementation.
Development Information
Replace the following standards
DL/T 735-2000
Related Standards
GB/T 1029-1993
Replaced
GB/T 1029-1993 Test procedures for three-phase synchronous machines
GB/T 4997-1993
Replaced
GB/T 4997-1993 Permanent magnet low speed direct current tachogenerator, General specification for
GB/T 7408-1994
Replaced
GB/T 7408-1994 Data elements and interchange formats—Information interchange—Representation of dates and times
GB/T 15548-1995
Replaced
GB/T 15548-1995 General specification for three-phase synchronous generator driven by reciprocating internal combustion engine
GB/T 7409.1-1997
Replaced