GB/T 26548.13-2025 Hand-held portable power tools—Test methods for evaluation of vibration emission—Part 13:Fastener driving tools

Scope

This document describes the test method for measuring hand-transmitted vibration at the handle of fastener driving tools. It specifies the type test procedure for determining the magnitude of vibration at the handle grip when operating the machine under a specific load. This document applies to fastener driving tools driven by compressed air or other means, using nails, U-shaped nails, or pins. This document applies to tools with single-sequence firing, touch-trigger firing, automatic reset touch-trigger firing, or continuous touch-trigger firing (see Figures 1–3). This document does not apply to tools operating in full-sequence firing mode, as the interval time between individual firings is much longer in this case. However, Appendix C provides informative guidance for comparing the vibration values of different tools of this type (see Figures 4 and 5). Note: Current knowledge does not allow any conclusions to be drawn about the physiological and pathological effects of single and continuous impacts, as well as their repetition rate.

Development Information

Same series standard

Referenced Standards

Adopt standards

Related Standards