T/SOECC 005-13-2022 Painted copper-clad aluminum round wire - Part 13: 180-level self-adhesive polyester-imide-clad copper-clad aluminum round wire

Scope

Main Technical Content: Copper-clad Aluminum Round Wire for Winding, Part 13: 180-Grade Self-Adhesive Polyester Imines Copper-clad Aluminum Round Wire 1 Scope This part specifies the requirements for 180-grade self-adhesive copper-clad aluminum round wire with a double-layer coating. The inner layer is based on polyester imine resin. If the chemical properties of the original resin can be preserved and all the requirements of this wire specification are met, the resin can be modified. The outer layer is a self-adhesive layer based on thermoplastic resin. Note: A modified resin is a resin that has undergone chemical changes or contains one or more additives to improve its performance or usage characteristics. The temperature rating "180" indicates the thermal class, requiring a minimum temperature index of 180 and a thermal shock temperature of at least 200°C. The Celsius temperature corresponding to the temperature index does not necessarily represent the recommended operating temperature of the wire, as this depends on many factors, including the type of equipment used. The nominal diameter range of the conductor specified in this part is: — Class 1B: 0.071 mm and above, 1.600 mm and below; — Class 2B: 0.071 mm and above, 1.600 mm and below. The nominal diameter of the conductor is in accordance with the provisions of Chapter 4.2 of Part 1. 2 Normative Reference Documents The provisions of the following documents are incorporated by reference into this part through T/SOECC: - Any dated reference document, except for its errata, does not apply to this part. However, parties reaching agreements based on this part are encouraged to investigate whether the latest version of these documents can be used. - Any undated reference document, the latest version of which applies to this part. T/SOECC 005.1–2022: Copper-clad Aluminum Round Wire for Winding — Part 1: General Provisions 3 Definitions, Test Methods and General Requirements 3.1 Defin

Development Information

Related Standards