T/JSEFA 005-2023 Active

Main Technical Content: 5. Technical Requirements 5.1 General Requirements 5.1.1 All moving parts of the machine should operate smoothly, coordinately, and accurately, without any jamming or abnormal noise. 5.1.2 The welded parts of the machine should have strong, uniform, and smooth welds, with slag removed. There should be no defects such as cracks, burn marks, undercuts, missed welds, weak welds, or inclusion. 5.1.3 The surface of machined parts should be smooth and flat, free from burrs or flying edges, and cracks. 5.1.4 Stamped parts should have flying edges and burrs removed, and no wrinkles or cracks. 5.1.5 Castings should not have cracks or casting defects such as air holes, sand holes, shrinkage, or inclusion that affect strength or appearance quality. 5.2 Performance Requirements The main performance indicators of the mushroom solid inoculation machine should comply with Table 1. Table 1: Main Performance Indicators of the Mushroom Solid Inoculation Machine Serial No. Item Indicators 1 Pure working hour productivity/bags/h Meet the design value 2 Inoculation rate/% ≥99 3 Average inoculation quantity per hole/g 15±4 4 Quality of inoculated mycelium surface after inoculation Breakage rate of bags ≤1% 5.3 Safety Requirements 5.3.1 Exposed gears, chain drives, and other dangerous moving parts should have robust and reliable safety protection devices that comply with the requirements of GB 10395.1-2009. 5.3.2 The safe distance between human upper and lower limbs and dangerous areas should comply with the requirements of GB 23821-2009. 5.3.3 The mushroom solid inoculation machine should have clear and conspicuous safety warning signs that comply with GB 10396. 5.3.4 The mushroom solid inoculation machine should be equipped with an emergency stop switch, and the emergency stop command should remain effective until it is reset manually. The reset should not restart the machine. 5.3.5 The mushroom soli