T/SZZL 012-2022 Active

Main Technical Content: 4.1 Requirements 4.1.1 Structure Type of the Anti-Collision Buffer Vehicle in Operating Condition (See Figure 1) 4.2 Whole Vehicle 4.2.1 The anti-collision buffer vehicle shall be manufactured in accordance with the requirements of this document and the approved product drawings and technical documents in accordance with the prescribed procedures. 4.2.2 Purchased parts and outsourced components shall comply with relevant regulations and have the manufacturer's quality certificate. They can only be used after being inspected and approved by the vehicle manufacturer. All self-made components shall be inspected and approved before assembly. 4.2.3 The outer contour dimensions, axle load, and mass limits shall comply with the provisions of GB 1589. 4.2.4 The driving safety requirements of the anti-collision buffer vehicle shall comply with the provisions of GB 7258. 4.2.5 The installation requirements of the external lighting and light signaling devices of the anti-collision buffer vehicle shall comply with the provisions of GB 4785 and GB 7258. 4.2.6 The paint coating shall comply with the provisions of QC/T 484. The electroplating layer and chemical treatment layer shall comply with the provisions of QC/T 625. 4.2.7 The welded parts shall comply with the provisions of JB/T 5943. 4.2.8 All control mechanisms and switches shall have clear markings. For operational anti-collision buffer vehicles, interconnected signal devices or interlocking devices shall be provided. For anti-collision buffer vehicles with lifting devices, stop and reverse buttons or handles shall be installed on the side of the lifting mechanism, and clear markings shall be provided. 4.2.9 The side protection and rear lower protection of the anti-collision buffer vehicle shall comply with the provisions of GB 11567. 4.2.10 The emissions of the anti-collision buffer vehicle shall comply with the provisions of GB 3847. 4.2.11 The appearance quality of th