GB 440-1977
Active
GB/T 5018-2008
Active
National standards
GB/T 5018-2008 Standard test method for determining corrosion preventive properties of lubricating greases
GB/T 5018-2008 Standard test method for determining corrosion preventive properties of lubricating greases
Basic Information
Standard Code:
GB/T 5018-2008
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Lubricating grease
ICS Name:
Lubricants, industrial oils, and related products
Publish Date:
2008-02-13
Implement Date:
2008-09-01
Pages:
13 pages
Scope
This standard specifies the method of determining the anti-corrosion performance of grease under wet conditions using cone roller bearings coated with grease. This standard is based on the CRC technical document L41, which shows the correspondence between the results of laboratory evaluations and the actual use results of aircraft wheel bearings lubricated with grease.
Development Information
Replace the following standards
Referenced Standards
Adopt standards
ASTM D1743-05a
Related Standards
GB/T 3142-1982
Replaced
GB/T 3142-1982 Lubricants—Determination of load-carrying capacity (four balls method)
GB/T 3498-1983
Replaced
GB/T 3498-1983 Lubricating greases—Determination of dropping point (wide temperature range)
GB/T 4929-1985
Active
GB/T 4929-1985 Lubricating grease—Determination of dropping point
GB/T 5018-1985
Replaced
GB/T 5018-1985 Standard test method for corrosion preventive properties of lubricating greases
GB/T 6144-1985
Replaced