T/APSW 005-2022 Active Group standards

T/APSW 005-2022 Diamond-shaped Metal Mesh Forming Machine

T/APSW 005-2022

Publish Date: 2022-12-20 Implement Date: 2022-12-21 For services related to genuine standard inquiry, procurement, translation, and other related services in China, please Contact Us

Price: $ 20.00

Out of stock

Basic Information

Standard Code: T/APSW 005-2022

Standard Type: Group standards

Standard Status: Active

is_force_gb: no

CCS Name: -

ICS Name: The manufacturing molding process

Publish Date: 2022-12-20

Implement Date: 2022-12-21

Scope

Main Technical Content: 4. Classification, Basic Parameters, and Models 4.1 Classification The forming machine is classified according to the number of incoming steel wires and the number of winding shafts, including double-wire double-mold forming machines, double-wire single-mold forming machines (referred to as "double-wire forming machines"), and single-wire single-mold forming machines (referred to as "single-wire forming machines"). 4.2 Basic Parameters The basic parameters of the forming machine shall comply with the provisions in Table 1. ? Table 1: Basic Parameters Maximum width of the mesh (mm): 2000, 2500, 3100, 4000, 6000 Wire diameter (mm): 2.0–5.0 Note: Upon mutual agreement between the supplier and the buyer, the wire diameter range and maximum mesh width can also be specified. 4.3 Model Designation Method The model designation method consists of the following codes: name code, number of incoming steel wires, number of winding shafts, maximum mesh width, and mesh aperture dimensions. The model designation method is shown in Figure 1. Figure 1: Model Designation Method Example 1: A double-wire double-mold forming machine for producing rhombus-shaped mesh with a maximum width of 2500 mm, with 2 incoming steel wires and 2 winding shafts, a mesh aperture range of 20–100 mm, and a roll-up mesh device. The model is designated as: BL S2-2500-100-J Example 2: A double-wire single-mold forming machine for producing rhombus-shaped mesh with a maximum width of 3100 mm, with 2 incoming steel wires and 1 winding shaft, a mesh aperture range of 30–80 mm, and a roll-up mesh device. The model is designated as: BL S1-3100-80-J Example 3: A single-wire single-mold forming machine for producing rhombus-shaped mesh with a maximum width of 2000 mm, with 1 incoming steel wire and 1 winding shaft, a mesh aperture range of 20–160 mm, and a roll-up device. The model is designated as: BL D1-2000-160-S5 Technical Requirements 5.1 General Requi