GB/T 22200.5-2025 Pending National standards

GB/T 22200.5-2025 Reliability of low-voltage apparatus—Part 5:Reliability test method of residual current operated circuit-breaker for household and similar uses

GB/T 22200.5-2025 Reliability of low-voltage apparatus—Part 5:Reliability test method of residual current operated circuit-breaker for household and similar uses

Publish Date: 2025-12-31 Implement Date: 2026-07-01 For services related to genuine standard inquiry, procurement, translation, and other related services in China, please Contact Us

Basic Information

Standard Code: GB/T 22200.5-2025
Standard Type: National standards
Standard Status: Pending
is_force_gb: no
CCS Name: Low-voltage distribution electrical equipment
ICS Name: Fuses and other overload protection devices
Publish Date: 2025-12-31
Implement Date: 2026-07-01
Publisher: 国家市场监督管理总局、国家标准化管理委员会
Technical Committee: 全国低压电器标准化技术委员会(SAC/TC 189)
Pages: 28 pages

Scope

本文件规定了家用和类似用途的剩余电流动作断路器(以下简称“剩余电流动作断路器”)的可靠性指标、可靠性试验方法、可靠性验证试验方案及试验程序、试验记录、带电操作下可靠性试验方法与步骤。
本文件适用于符合GB/T 16916.1或GB/T 16917.1规定的可靠性试验方法,适用于交流50 Hz、60 Hz或50 Hz/60 Hz,额定电压不超过440 V,额定电流不超过125 A,额定短路能力不超过25 000 A,动作功能与电源电压无关或与电源电压有关的家用和类似用途的带过电流保护或不带过电流保护的剩余电流动作断路器。符合GB/T 14048.2等标准的剩余电流断路器的可靠性等级及试验方法参照本文件的有关内容。

Development Information

Drafting Units:

河北工业大学、上海电器科学研究院、施耐德电气(中国)有限公司上海分公司、德力西电气有限公司、上海西门子线路保护系统有限公司、北京ABB低压电器有限公司、浙江正泰电器股份有限公司、上海良信电器股份有限公司、苏州未来电器股份有限公司、科都电气股份有限公司、圣普电气有限公司、佛山安德慧智能科技有限公司、加西亚电子电器股份有限公司、中电装备山东电子有限公司

Drafting Persons:

李奎、陈雪琴、邱蔚冰、祁卫华、樊震、熊厚钰、朱俊、杨卫、楼铭达、李子平、李铁军、龙焕祥、牛峰、王尧、穆甲凯、孟令欣、刘帼巾

Word Count: 48 Thousand words Pages: 28 pages

Same series standard

Replace the following standards

Referenced Standards

GB/T 2900.18-2008 Electrotechnical terminology—Low voltage apparatus GB/T 2900.99-2016 Electrotechnical terminology—Dependability GB/T 2424.2-1993 Basic environmental testing procedures for electric and electronic products Guidance for damp heat tests GB/T 2424.2-2005 Environment tests for electric and electronic products—Guidance for damp heat tests GB/T 2423.4-1993 Basic environmental testing procedures for electric and electronic products—Test Db:Damp heat, cyclic GB/T 2423.4-2008 Environmental testing for electric and electronic products—Part 2:Test method—Test Db:Damp heat,cyclic(12 h+12 h cycle) GB/T 5080.1-1986 Equipment reliability testing—General requirements GB/T 5080.1-2012 Reliability testing—Part 1:Test conditions and statistical test principles GB/T 5080.2-1986 Equipment reliability testing—Guidance for the design of test cycles GB/T 5080.2-2012 Reliability testing—Part 2:Design of test cycles GB/T 5080.4-1985 Equipment reliability testing—Procedure for point estimates and confidence intervals from reliability determination tests(Exponental distribution) GB/T 5080.5-1985 Equipment reliability testing—compliance test plans for success ratio GB/T 5080.6-1996 Equipment reliability testing—Tests for the validity of a constant failure rate assumption GB/T 5080.7-1986 Equipment reliability testing Compliance test plans for failure rate and mean time between failures assuming constant failure rate GB/T 6829-2024 General safety requirements for residual current operated protective devices GB/T 16916.1-2014 Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses (RCCB)—Part 1:General rules GB/T 16917.1-2014 Residual current operated circuit-breakers with integral overcurrent protection for household and similar uses (RCBOs)—Part 1:General rules GB/T 19334-2021 Dimensions of low-voltage switchgear and controlgear—Standardized mounting on rails for mechanical support of switchgear,controlgear and accessories GB/T 22200.1-2025 Reliability for low-voltage apparatus—Part 1:General rules

Related Standards

Contact Us