GB/T 17799.2-2003
Replaced
GB/T 17799.2-2023
Active
National standards
GB/T 17799.2-2023 Electromagnetic compatibility—Generic standards—Part 2: Immunity standard for industrial environments
GB/T 17799.2-2023 Electromagnetic compatibility—Generic standards—Part 2: Immunity standard for industrial environments
Price:
$ 66
Basic Information
Standard Code:
GB/T 17799.2-2023
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Electromagnetic compatibility
ICS Name:
\nImmunity to interference
Publish Date:
2023-05-23
Implement Date:
2023-12-01
Pages:
15 pages
Scope
The electromagnetic compatibility (EMC) immunity requirements of this document apply to the following electrical and electronic equipment used in industrial environments, covering a frequency range of 0 Hz to 400 GHz. No testing is required at frequencies where immunity requirements are not specified. If there are no dedicated EMC immunity standards for a specific product or product category, this general EMC immunity standard applies. This document applies to electrical and electronic equipment operating in industrial environments (as defined in Section 3.7), including indoor and outdoor locations. It also applies to equipment directly connected to DC power distribution networks or powered by batteries, and used in industrial environments. This document specifies immunity test requirements for continuous and transient disturbances, conducted and radiated disturbances, and electrostatic discharge (ESD) for equipment within its scope of application. The immunity requirements specified in this document are designed to ensure that equipment operating in industrial environments meets an appropriate level of immunity. However, these immunity levels do not address extremely rare extreme situations that may occur in any environment. The tests recommended in this document do not cover all disturbance phenomena, but only those relevant to the equipment covered by this document. These test requirements represent basic EMC immunity requirements. This document specifies test requirements for each port considered.
Development Information
Same series standard
GB 17799.3-2023 Electromagnetic compatibility(EMC)—Generic standards—Part 3:Emission standard for equipment in residential environments
GB 17799.8-2023 Electromagnetic compatibility (EMC)—Generic standards—Part 8:Emission standard for professional equipment in commercial and light-industrial locations
Replace the following standards
Referenced Standards
GB/T 17626.21-2014 Electromagnetic compatibility—Testing and measurement techniques—Reverberation chamber test methods
IEC 60050-161
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
IEC 61000-4-11
IEC 61000-4-20
IEC 61000-4-22
IEC 61000-4-34
Adopt standards
IEC 61000-6-2:2016
Related Standards
GB/T 17626.14-2005
Active
GB/T 17626.14-2005 Electromagnetic compatibility—Testing and measurement techniques—Voltage fluctuation immunity test
GB/T 17626.17-2005
Active
GB/T 17626.17-2005 Electromagnetic Compatibility—Testing and measurement techniques—Ripple on d.c.input power port immunity test
GB/T 17626.2-2006
Replaced
GB/T 17626.2-2006 Electromagnetic compatibility—Testing and measurement techniques—Electrostatic discharge immunity test
GB/T 17626.29-2006
Active
GB/T 17626.29-2006 Electromagnetic compatibility—Testing and measurement techniques—Voltage dips, short interruptions and voltage variations on d.c .input power port immunity tests
GB/T 17626.3-2006
Replaced