T/SOECC 005-6-2022 Painted copper-clad aluminum round wire - Part 6: 200-level polyamide-imide composite polyester or copper-clad aluminum round wire with polyester-imide paint coating

Scope

Main Technical Content: Copper-Clad Aluminum Round Coil Wire, Part 6: 200-Grade Polyamide-Imide Composite Polyester or Polyester-Imide Copper-Clad Aluminum Round Wire 1 Scope This part specifies the requirements for 200-grade copper-clad aluminum round wire with a double-layer coating. The base layer of the coating is made of polyester or polyester-imide resin. If the chemical properties of the original resin can be preserved and all the requirements of this wire specification are met, the resin can be modified. The top layer is based on polyamide-imide resin. Note: A modified resin is a resin that has undergone chemical changes or contains one or more additives to improve its performance or usage characteristics. 200-grade indicates the thermal class, which requires a minimum temperature index of 200 and a thermal shock temperature of at least 220°C. The Celsius temperature corresponding to the temperature index is not the recommended operating temperature of the wire, as this depends on many factors, including the type of equipment used. The nominal diameter range of the conductor specified in this part is: — Class 1: 0.071 mm and above, 2.000 mm and below; — Class 2: 0.071 mm and above, 5.000 mm and below. The nominal diameter of the conductor is in accordance with the provisions of Chapter 4.2 of Part 1. 2 Normative Reference Documents The provisions of the following documents are incorporated into this part by reference through T/SOECC. For dated reference documents, all subsequent amendment sheets (excluding errata) or revised editions are not applicable to this part. However, parties reaching agreements based on this part are encouraged to study whether the latest versions of these documents can be used. For undated reference documents, the latest versions apply to this part. T/SOECC 005.1-2022 Copper-Clad Aluminum Round Coil Wire, Part 1: General Provisions 3 Definitions, General Test Methods, and Appearance 3.1 Definitions, General

Development Information

Related Standards