T/APSW 002-2021 Active Group standards

T/APSW 002-2021 DeerNet

Publish Date: 2021-12-30 Implement Date: 2021-12-30 For services related to genuine standard inquiry, procurement, translation, and other related services in China, please Contact Us

Price: $ 20.00

Out of stock

Basic Information

Standard Code: T/APSW 002-2021

Standard Type: Group standards

Standard Status: Active

is_force_gb: no

CCS Name: Wire products

ICS Name: Other steel products

Publish Date: 2021-12-30

Implement Date: 2021-12-30

Scope

Scope: 1 Scope This document specifies the terminology and definitions, technical requirements, test methods, inspection rules, packaging, marking, transportation, and storage of deer fences. This document is applicable to deer fences used for animal containment, and farms and parks can also refer to it for use. Main Technical Content: 2 Normative Reference Documents The content of the following documents is essential to this document through normative reference. Among them, the referenced documents with a specified date apply only to the version corresponding to that date; the latest version (including all amendment sheets) of the unspecified date referenced documents applies to this document. - YB/T 5294: General-purpose low-carbon steel wire - YB/T 5303: High-quality carbon structural steel wire - YB/T 5357: Steel wire and its products; zinc or zinc-aluminum alloy coating 3 Terminology and Definitions The following terms and definitions apply to this document. - Deer fence - Fixed knot fence - A steel wire mesh panel used to enclose deer and other animals, consisting of knotted wires arranged at the intersections of warp and weft wires, as shown in Figure 1. - Knotted wire - Edge wire - Inner wire - Mesh size - Roll diameter 4 Technical Requirements Raw materials The diameter and mechanical properties of raw wires shall comply with Table 1. - Table 1: Diameter and mechanical properties of raw wires - Diameter and mechanical properties: Warp and weft wires shall comply with YB/T 5303; knotted wires shall comply with YB/T 5294; and the zinc-coated layers of warp, weft, and knotted wires shall comply with YB/T 5357. - Specifications and tolerances: Common specifications, mesh arrangement, roll diameter, weight, and allowable tolerances are shown in Appendix A. - The allowable tolerance of mesh size is ±5%. - The wave pattern of the weft wires shall be agreed upon by both parties. - Structure type: After folding