GB/T 6931.1-1986
Replaced
GB/T 15531-2008
Replaced
National standards
GB/T 15531-2008 Belt drives—Pulleys—Limiting values for adjustment of centres
GB/T 15531-2008 Belt drives—Pulleys—Limiting values for adjustment of centres
Basic Information
Standard Code:
GB/T 15531-2008
Standard Type:
National standards
Standard Status:
Replaced
is_force_gb:
no
CCS Name:
Chain drive, belt drive, and key connection
ICS Name:
Belt drive and its components
Publish Date:
2008-08-25
Implement Date:
2009-03-01
Pages:
7 pages
Scope
This standard specifies the adjustment limit values for the center distance between two drive belt pulleys. This standard applies to the determination of the adjustment limit values for the center distance between two drive belt pulleys as follows: a) Convex flat belt pulleys; b) Single V-belt pulleys, multiple V-belt pulleys, and combined V-belt pulleys; c) Multi-wedge belt pulleys; d) Trapezoidal toothed synchronous belt pulleys.
Development Information
Replace the following standards
Superseded by the following standards
Referenced Standards
Adopt standards
ISO 155:1998
Related Standards
GB/T 6931.2-1986
Replaced
GB/T 6931.2-1986 Drives using V-belts and grooved pulleys—Terminology
GB/T 6931.3-1986
Replaced
GB/T 6931.3-1986 Synchronous belt drives—Terminology
GB/T 11616-1989
Replaced
GB/T 11616-1989 Synchronous belts—Dimensions
GB/T 12735-1991
Replaced
GB/T 12735-1991 Fatigue test method for agricultural V-belts
GB/T 13490-1992
Replaced