T/HSIPA 001-2021 Multifunctional Physical Therapy Mat
T/HSIPA 001-2021 Multifunctional Physical Therapy Mat
Basic Information
Scope
Scope: This document specifies the terms and definitions, basic requirements, operating procedures and requirements, precautions, and contraindications for multifunctional physiotherapy pads. This document is applicable to medical institutions, health care centers, and home-based preventive health care techniques. **Main Technical Content**: 1. Scope: This document specifies the terms and definitions, basic requirements, operating procedures and requirements, precautions, and contraindications for multifunctional physiotherapy pads. This document is applicable to medical institutions, health care centers, and home-based preventive health care techniques. 2. Normative References: The following documents are essential for the application of this document. 3. Terms and Definitions: The following terms and definitions are defined and applicable to this document. 3.1 Multifunctional Physiotherapy Pad 3.2 Far Infrared Function 3.3 Negative Ion Property 3.4 Bioelectrical Characteristics 4. Basic Requirements 4.1 Classification of Physiotherapy Pads 4.2 Specifications of Physiotherapy Pads 4.3 Technical Requirements 4.3.1 The multifunctional physiotherapy pad heater shall comply with the technical requirements of GB/T 4654-2008. 4.3.2 The multifunctional physiotherapy pad shall have a rated voltage of 220V and a power range of 320W (+5~-10). 4.3.3 Starting from a room temperature of 20℃, the multifunctional physiotherapy pad shall heat up to 60℃ within 15 minutes. After the electrical operation reaches thermal equilibrium, the actual temperature and set temperature deviation shall be within ±5℃. 4.3.4 The far infrared wave length range shall be between 4μm and 16μm. 4.3.5 The normal emissivity shall be not less than 0.85. The electrical-thermal radiation conversion efficiency shall be greater than 65%. 4.3.6 At a temperature of 40℃, the negative ion concentration shall be >2500/cm3. 4.3.7 The formaldehyde emission limit of the multif