GB/T 14824-2008
Replaced
T/CEEIA 321-2018
Active
Group standards
T/CEEIA 321-2018 Mechanical fault testing guidelines for isolation switches - Torque-angle method
T/CEEIA 321-2018 Mechanical fault testing guidelines for isolation switches - Torque-angle method
Price:
$ 20.00
Basic Information
Standard Code:
T/CEEIA 321-2018
Standard Type:
Group standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Health, safety, and labor protection
ICS Name:
Integrated switch devices and controllers
Publish Date:
2018-12-24
Implement Date:
2018-12-24
Scope
Scope: This standard provides the terms and definitions for testing the mechanical faults of disconnecting switches based on the operating torque-angle analysis method, the requirements for testing instruments, testing methods, and the determination of test faults. This standard applies to the on-site testing of open-type disconnecting switches with a voltage rating of 40.5 kV and above. Main technical content: This standard provides the terms and definitions for testing the mechanical faults of disconnecting switches based on the operating torque-angle analysis method, the requirements for testing instruments, testing methods, and the determination of test faults. This standard applies to the on-site testing of open-type disconnecting switches with a voltage rating of 40.5 kV and above.
Development Information
Related Standards
GB/Z 25842.1-2010
Active
GB/Z 25842.1-2010 Low-voltage switchgear and controlgear—Overcurrent protective devices—Part 1:Application of short-circuit ratings
GB/T 18858.1-2012
Active
GB/T 18858.1-2012 Low-voltage switchgear and controlgear—Controller-device interface(CDI)—Part 1:General rules
GB/T 18858.2-2012
Active
GB/T 18858.2-2012 Low-Voltage switchgear and controlgear—Controller-device interfaces(CDI)—Part 2:Actuator sensor interface(AS-i)
GB/T 18858.3-2012
Active
GB/T 18858.3-2012 Low-voltage switchgear and controlgear—Controller-device interface(CDI)—Part 3:DeviceNet
GB/Z 25842.2-2012
Active