GB/T 3750.3-1983
Replaced
GB/T 13807.2-2008
Active
National standards
GB/T 13807.2-2008 Connections with waisted stud—Studs
GB/T 13807.2-2008 Connections with waisted stud—Studs
Basic Information
Standard Code:
GB/T 13807.2-2008
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Fasteners
ICS Name:
Bolts, screws, and studs
Publish Date:
2008-08-25
Implement Date:
2009-02-01
Pages:
11 pages
Scope
This section specifies the equatorial rods and equal-length double-headed studs with thread sizes of M12 to M180 × 6; M12 to M120 × 6 equatorial rods and double-headed studs. This section is applicable to fasteners that can withstand high temperatures and alternating loads, and also maintain a considerable degree of pre-tension force and fatigue resistance under working conditions.
Development Information
Same series standard
Replace the following standards
Referenced Standards
GB/T 90.1-2002 Fasteners—Acceptance inspection
GB/T 90.1-2023 Fasteners—Acceptance inspection
GB/T 90.2-2002 Fasteners—Marking and packaging
GB/T 145-2001 Center holes
GB/T 196-2003 General purpose metric screw threads—Basic dimensions
GB/T 197-2003 General purpose metric screw threads—Tolerances
GB/T 197-2018 General purpose metric screw threads—Tolerances
GB/T 1237-2000 Designation system for fasteners
GB/T 3098.8-1992 Mechanical properties of fasteners—Components for bolted connections made mainly from materials with a high temperature strength
GB/T 3098.8-2010 Mechanical properties of fasteners Parts for bolted connections for use at temperatures from -200 ℃～+700 ℃
GB/T 3103.4-1992 Tolerances for fasteners—Components for bolted connections made mainly from materials with a high temperature strength
GB/T 3103.4-2014 Tolerances for fasteners—Bolt/nut assemblies for service temperatures from -200 ℃～＋700 ℃
GB/T 13807.1-1992 Connections with waisted stud—Tape classification
GB/T 13807.1-2008 Connections with waisted stud—Tape classification
GB/T 3-1997 Run-outs，undercuts and chamfers forgeneral purpose metric screw threads
GB/T 196-2025 General purpose metric screw threads—Basic dimensions
GB/Z 145-2025 Course development guide for education about standardization—Logistics standardization
Adopt standards
DIN 2510-3:1971
DIN 2510-4:1971
DIN 2510-8:1971
Related Standards
GB/T 5277-1985
Active
GB/T 5277-1985 Fasteners—Clearance holes for bolts and screws
GB/T 6560-1986
Replaced
GB/T 6560-1986 Cross recessed pan head thread forming screws
GB/T 6561-1986
Replaced
GB/T 6561-1986 Cross recessed countersunk head thread forming screws
GB/T 6562-1986
Replaced
GB/T 6562-1986 Cross recessed raised countersunk head thread forming screws
GB/T 6563-1986
Replaced