MT 395-1995 Flashlight short circuit protection device

GB/T 2423.3-1993 Basic environmental testing procedures for electric and electronic products—Test Ca:Damp heat, steady state GB/T 2423.3-2006 Environmental testing for electric and electronic products—Part 2:Testing method—Test Cab:Damp heat, steady state GB/T 2423.3-2016 Environmental testing—Part 2:Testing method—Test Cab:Damp heat,steady state GB/T 2828.1-2003 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.1-2012 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.2-2008 Sampling procedures for inspection by attributes—Part 2:Sampling plans indexed by limiting quality(LQ)for isolated lot inspection GB/T 2828.3-2008 Sampling procedures for inspection by attributes—Part 3:Skip-lot sampling procedures GB/T 2828.4-2008 Sampling procedures for inspection by attributes—Part 4:Procedures for assessment of declared quality levels GB/T 2828.5-2011 Sampling procedures for inspection by attributes—Part 5:System of sequential sampling plans indexed by acceptance quality limit(AQL)for lot-by-lot inspection GB/T 2828.10-2010 Sampling procedures for inspection by attributes—Part 10:Introduction to the GB/T 2828 series of standards for sampling for inspection by attributes GB/T 2828.11-2008 Sampling procedures for inspection by attributes—Part 11:Procedures for assessment of declared quality levels for small population GB/T 2829-2002 Sampling procedures and tables for periodic inspection by attributes (Apply to inspection of process stability) GB 7957-2003 General requirements for safety of cap lamp GB/T 7957-2017 General requirements for construction,performance and explosion protected testing of caplights for use in mines susceptible to firedamp GB 7957-2023 Safety technical requirement for cap lamps in coal mine GB 7957.2-2009 Caplights for use in mines susceptible to firedamp—Part 2:Performance and other safety-related matters GB/T 2829-2025 Sampling procedures and tables for periodic inspection by attributes(Apply to inspection of process stability)