GB/T 22720.1-2017 Active National standards

GB/T 22720.1-2017 Rotating electrical machines—Qualification and quality control tests of partial discharge free electrical insulation systems(TypeⅠ) used in rotating electrical machines fed from voltage converters

Publish Date: 2017-11-01 Implement Date: 2018-05-01 For services related to genuine standard inquiry, procurement, translation, and other related services in China, please Contact Us

Basic Information

Standard Code: GB/T 22720.1-2017

Standard Type: National standards

Standard Status: Active

is_force_gb: no

CCS Name: Rotating motor

ICS Name: Rotating motor comprehensive

Publish Date: 2017-11-01

Implement Date: 2018-05-01

Pages: 33 pages

Scope

This part specifies the evaluation standards for the insulation structure of the stator/rotor windings of voltage-type pulse width modulation (PWM) power supplies. This part applies to the insulation structure of the stator/rotor windings of single-phase or multi-phase AC motors powered by frequency converters. This part specifies the identification and quality control (type and factory) tests conducted on typical samples or complete motors to verify their compatibility with voltage-type frequency converters. This part does not apply to: -- rotating motors started solely by frequency converters; -- rotating motors with a rated voltage effective value of ≤300 V; -- rotor windings of rotating motors with an operating voltage (peak value) of ≤200 V.

Development Information

Word Count: 56 Thousand words Pages: 33 pages

Replace the following standards

GB/T 22720.1-2008 Rotating electrical machines—Qualification and type tests for typeⅠ electrical insulation systems used in rotating electrical machines fed from voltage converters

Referenced Standards

GB/T 17948.7-2016 Rotating electrical machines—Functional evaluation of insulation systems—General guidelines IEC 60034-18-21 IEC 60034-18-31 IEC/TS 60034-18-42 IEC/TS 60034-25:2007 IEC/TS 60034-27 IEC 60172 IEC 60664-1 IEC/TS 61800-8 IEC/TS 61934

Adopt standards

IEC 60034-18-41:2014

Related Standards

GB/T 7346-1998 Replaced

GB/T 7346-1998 Basic outline constructional type for control motors and feedback components

Publish Date: 1998-01-19

GB/T 4772.1-1999 Replaced

GB/T 4772.1-1999 Dimensions and output series for rotating electrical machines—Part 1:Frame numbers 56 to 400 and flange numbers 55 to 1080

Publish Date: 1999-02-26

GB/T 4772.2-1999 Active

GB/T 4772.2-1999 Dimensions and output series for rotating electrical machines— Part 2:Frame numbers 355 to 1000 and flange numbers 1180 to 2360

Publish Date: 1999-02-26

GB/T 4772.3-1999 Active

GB/T 4772.3-1999 Dimensions and output series for rotating electrical machines— Part 3:Samll built-in motors flange numbers BF10 to BF50

Publish Date: 1999-02-26

GB 10068-2000 Replaced

GB 10068-2000 Mechanical vibration of certain machines with shaft heights 56mm and higher—Measurement,evaluation and limits of vibration

Publish Date: 2000-01-03

GB/T 17948.1-2000 Replaced

GB/T 17948.1-2000 Rotating electrical machines—Functional evaluation of insulation systems—Test procedures for wire-wound windings—Thermal evaluation and classification

Publish Date: 2000-01-03