QB/T 1201-1991 Hand-held carpenter's chisel

QB/T 1201-2017 Wooden hand chisel

GB/T 1804-2000 General tolerances for linear and angular dimensions without individual tolerance indications GB/T 230.1-2004 Metallic Rockwell hardness test—Part1:Test method(scales A、B、C、D、E、F、G、H、K、N、T) GB/T 230.1-2009 Metallic materials—Rockwell hardness test—Part 1:Test method(scales A、B、C、D、E、F、G、H、K、N、T) GB/T 230.1-2018 Metallic materials—Rockwell hardness test—Part 1:Test method GB/T 230.2-2002 Metallic rockwell hardness test—Part 2:Verification and calibration of hardness testers(scales A,B,C,D,E,F,G,H,K,N,T) GB/T 230.2-2012 Metallic materials—Rockwell hardness test—Part 2:Verification and calibration of testing machines GB/T 230.2-2022 Metallic materials—Rockwell hardness test—Part 2:Verification and calibration of testing machines and indenters GB/T 230.3-2002 Metallic rockwell hardness test—Part 3:Calibration of hardness reference blocks(scales A,B,C,D,E,F,G,H,K,N,T) GB/T 230.3-2012 Metallic materials—Rockwell hardness test—Part 3:Calibration of reference blocks(scales A,B,C,D,E,F,G,H,K,N,T) GB/T 230.3-2022 Metallic materials—Rockwell hardness test—Part 3:Calibration of reference blocks GB/T 2828.1-2003 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.1-2012 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.2-2008 Sampling procedures for inspection by attributes—Part 2:Sampling plans indexed by limiting quality(LQ)for isolated lot inspection GB/T 2828.3-2008 Sampling procedures for inspection by attributes—Part 3:Skip-lot sampling procedures GB/T 2828.4-2008 Sampling procedures for inspection by attributes—Part 4:Procedures for assessment of declared quality levels GB/T 2828.5-2011 Sampling procedures for inspection by attributes—Part 5:System of sequential sampling plans indexed by acceptance quality limit(AQL)for lot-by-lot inspection GB/T 2828.10-2010 Sampling procedures for inspection by attributes—Part 10:Introduction to the GB/T 2828 series of standards for sampling for inspection by attributes GB/T 2828.11-2008 Sampling procedures for inspection by attributes—Part 11:Procedures for assessment of declared quality levels for small population GB/T 5305-1985 Packaging,marking,transportation and storage of hand tools GB/T 5305-2008 Packaging,marking,transportation and storage of hand tools GB/T 6060.2-1985 Roughness comparison specimens—Ground, turned, bored,milled, shaped and planed GB/T 6060.2-2006 Roughness comparison specimens—Ground,turned,bored,milled,shaped and planed

ISO 2729:1973