GB/T 14296-1993 Air cooling and air heating coils

GB/T 14296-2008 Air cooling and air heating coils

GB 9119.6 GB 9119.7 GB 9119.8 GB 10223 GB/T 1047-1995 Nominal size for pipe components GB/T 1047-2005 Pipework components—Definition and selection of DN (nominal size) GB/T 1047-2019 Pipework components—Definition and selection of nominal size GB/T 1804-2000 General tolerances for linear and angular dimensions without individual tolerance indications GB/T 1958-2004 Geometrical product Specifications(GPS)—Geometrical tolerance—Verification prescription GB/T 1958-2017 Geometrical Product Specifications(GPS)—Geometrical tolerance—Verification GB/T 2828.1-2003 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.1-2012 Sampling procedures for inspection by attributes—Part 1:Sampling schemes indexed by acceptance quality limit(AQL) for lot-by-lot inspection GB/T 2828.2-2008 Sampling procedures for inspection by attributes—Part 2:Sampling plans indexed by limiting quality(LQ)for isolated lot inspection GB/T 2828.3-2008 Sampling procedures for inspection by attributes—Part 3:Skip-lot sampling procedures GB/T 2828.4-2008 Sampling procedures for inspection by attributes—Part 4:Procedures for assessment of declared quality levels GB/T 2828.5-2011 Sampling procedures for inspection by attributes—Part 5:System of sequential sampling plans indexed by acceptance quality limit(AQL)for lot-by-lot inspection GB/T 2828.10-2010 Sampling procedures for inspection by attributes—Part 10:Introduction to the GB/T 2828 series of standards for sampling for inspection by attributes GB/T 2828.11-2008 Sampling procedures for inspection by attributes—Part 11:Procedures for assessment of declared quality levels for small population GB/T 2829-2002 Sampling procedures and tables for periodic inspection by attributes (Apply to inspection of process stability) GB/T 7306.1-2000 Pipe threads with 55 degree thread angle where pressure-tight joints are made on the threads—Part 1:Parallel internal and taper external threads GB/T 7306.2-2000 Pipe threads with 55 degree thread angle where pressure-tight joints are made on the threads—Part 2:Taper internal and external threads GB/T 2829-2025 Sampling procedures and tables for periodic inspection by attributes(Apply to inspection of process stability)