GB/T 11334-1989
Replaced
GB/T 1800.2-2009
Replaced
National standards
GB/T 1800.2-2009 Geometrical Product Specifications (GPS)—Limits and fits—Part 2:Tables of standard tolerance grades and limit deviations for holes and shafts
GB/T 1800.2-2009 Geometrical Product Specifications (GPS)—Limits and fits—Part 2:Tables of standard tolerance grades and limit deviations for holes and shafts
Basic Information
Standard Code:
GB/T 1800.2-2009
Standard Type:
National standards
Standard Status:
Replaced
is_force_gb:
no
CCS Name:
Basic standards and general methods
ICS Name:
Limits and coordination
Publish Date:
2009-03-16
Implement Date:
2009-11-01
Pages:
59 pages
Scope
This part of GB/T 1800 specifies the limit deviation values of the commonly used tolerance zones for holes and shafts, which are calculated based on the standard tolerance and basic deviation values table in GB/T 1800.1. It includes the values of the upper limit deviation ES of holes and the upper limit deviation es of shafts, as well as the lower limit deviation EI of holes and the lower limit deviation ei of shafts (see Figure 1).
This part is applicable to the dimensional elements of cylindrical and non-cylindrical smooth workpieces.
Development Information
Same series standard
Replace the following standards
Superseded by the following standards
Referenced Standards
Adopt standards
ISO 286-2:1988
Related Standards
GB/T 12360-1990
Replaced
GB/T 12360-1990 Cone fit
GB/T 1182-1996
Replaced
GB/T 1182-1996 Geometrical tolerancing—Generalities, definitions, symbols, indications on drawings
GB/T 1184-1996
Active
GB/T 1184-1996 Geometrical tolerancing—Geometrical tolerance for features without individual tolerance indications
GB/T 16671-1996
Replaced
GB/T 16671-1996 Geometrical tolerancing—Maximum material requirement, least material requirement and reciprocity requirement
GB/T 4249-1996
Replaced