GB 6450-1986
Replaced
GB/T 26217-2019
Active
National standards
GB/T 26217-2019 DC voltage measuring device for HVDC transmission system
GB/T 26217-2019 DC voltage measuring device for HVDC transmission system
Price:
$ 75
Basic Information
Standard Code:
GB/T 26217-2019
Standard Type:
National standards
Standard Status:
Active
is_force_gb:
no
CCS Name:
Transformer
ICS Name:
Transformers, reactors, and inductors
Publish Date:
2019-12-10
Implement Date:
2020-07-01
Pages:
20 pages
Scope
This standard specifies the normal and special operating conditions, rated values, design and structure, testing, and nameplates of DC voltage measurement devices used in DC transmission with voltage levels of ±1 100 kV and below.
This standard applies to DC voltage measurement devices installed at voltage levels of ±1 100 kV and below. Typical installation locations include the DC pole bus, the midpoint bus of the dual-twelve-pulse converter valve group (if applicable), the neutral bus, the grounding electrode lead, and the bridge arm circuit of the flexible DC transmission system, etc.
Development Information
Replace the following standards
Referenced Standards
GB/T 311.1-2012 Insulation co-ordination—Part 1:Definitions,principles and rules
GB/T 11022-2011 Common specifications for high-voltage switchgear and controlgear standards
GB/T 20840.3-2013 Instrument transformers—Part 3:Additional requirements for inductive voltage transformers
GB/T 20840.5-2013 Instrument transformers—Part 5:Additional requirements for capacitor voltage transformers
GB/T 20840.7-2007 Instrument transformers—Part 7:Electronic voltage transformers
GB/T 20840.8-2007 Instrument transformers—Part 8:Electronic current transformers
GB/T 22071.2-2017 Test guide for instrument transformers—Part 2:Inductive voltage transformers
GB/T 2424.25-2000 Environmental testing for electric and electronic products—Part 3:Test guidance-Seismic test methods
GB/T 2900.1-1992 Electrotechnical terminology—Fundamental terms
GB/T 2900.1-2008 Electrotechnical terminology—Fundamental terms
GB 4208-1993 Degrees of protection provided by enclosure (IP code)
GB/T 4208-2008 Degrees of protection provided by enclosure(IP code)
GB/T 4208-2017 Degrees of protection provided by enclosure(IP code)
GB/T 7354-2003 Partial discharge measurements
GB/T 7354-2018 High-voltage test techniques—Partial discharge measurements
GB/T 16927.1-1997 High-voltage test techniques Part 1:General test requirements
GB/T 16927.1-2011 High-voltage test techniques—Part 1:General definitions and test requirements
GB/T 16927.2-1997 High-voltage test techniques Part 2:Measuring systems
GB/T 16927.2-2013 High-voltage test techniques—Part 2:Measuring systems
GB/T 21429-2008 Composite insulators-Hollow insulators for use in outdoor and indoor electrical equipment—Definitions,test methods,acceptance criteria and design recommendations
GB/T 22079-2008 Polymeric insulators for indoor and outdoor use with a nominal voltage > 1 000 V—General definitions,test methods and acceptance criteria
GB/T 22079-2019 HV polymeric insulators for indoor and outdoor use—General definitions,test methods and acceptance criteria
GB/T 22707-2008 Artificial pollution tests on high-voltage insulators to be used on d.c.systems
GB/T 23752-2009 Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1000V
GB 50150-2016 Electric equipment installation engineering - standard for hand-over test of electric equipment
GB/T 2424.25-2024 Environmental testing—Part 3:Test guidance—Seismic test methods
Related Standards
GB/T 7449-1987
Replaced
GB/T 7449-1987 Guide to the lightning impulse and switching impulse testing of power transformers and reactors
GB 13028-1991
Abolished
GB 13028-1991 Isolating transformers and safety isolating transformers Requirements
GB/T 14006-1992
Active
GB/T 14006-1992 Outline dimensions of transformers and inductors for use in telecommunication and electronic equipment—Part 1:Transformers and inductors using YEI-1 laminations
GB/T 14860-1993
Replaced
GB/T 14860-1993 Generic specification for transformers and inductors for use in telecommunication and electronic equipment
GB/T 15164-1994
Replaced