GB/T 13540-1992
Replaced
GB/T 19214-2008
Replaced
National standards
GB/T 19214-2008 Electrical accessories—Residual current monitors (RCM) for household and similar uses
GB/T 19214-2008 Electrical accessories—Residual current monitors (RCM) for household and similar uses
Basic Information
Standard Code:
GB/T 19214-2008
Standard Type:
National standards
Standard Status:
Replaced
is_force_gb:
no
CCS Name:
Low-voltage distribution electrical equipment
ICS Name:
Switching devices and controllers
Publish Date:
2008-12-30
Implement Date:
2010-02-01
Pages:
65 pages
Scope
This standard applies to residual current monitors (hereinafter referred to as RCMs) for household and similar applications with a rated voltage not exceeding 440 V AC and a rated current not exceeding 125 A.
RCMs are used to monitor residual current in equipment and issue an alarm signal when the residual current between live components and exposed conductive parts or the ground exceeds a predetermined value.
The RCMs covered by this standard cannot be used as protective devices.
RCMs detect sudden or slowly rising AC residual current and pulsating DC residual current (see 8.16).
Development Information
Replace the following standards
Superseded by the following standards
Referenced Standards
GB 156-2003 Standard voltages
GB/T 156-2007 Standard voltages
GB/T 156-2017 Standard voltages
GB/Z 156-2025 Good practice for dynamic light scattering(DLS) measurements
GB/T 2423.4-2008 Environmental testing for electric and electronic products—Part 2:Test method—Test Db:Damp heat,cyclic(12 h+12 h cycle)
GB/T 2424.2-1993 Basic environmental testing procedures for electric and electronic products Guidance for damp heat tests
GB/T 2424.2-2005 Environment tests for electric and electronic products—Guidance for damp heat tests
GB/T 2900.18-2008 Electrotechnical terminology—Low voltage apparatus
GB/T 2099.83-2008
GB 4208-1993 Degrees of protection provided by enclosure (IP code)
GB/T 4208-2008 Degrees of protection provided by enclosure(IP code)
GB/T 4208-2017 Degrees of protection provided by enclosure(IP code)
GB/T 5169.10-2006 Fire hazard testing for electric and electronic products—Part 10:Glow/hot-wire based test methods—Glow-wire apparatus and common test procedure
GB/Z 6829-2008 General requirements for residual current operated protective devices
GB/T 7676.1-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 1:Definitions and general requirements common to all parts
GB/T 7676.1-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 1:Definitions and general requirements common to all parts
GB/T 7676.2-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 2:Special requirements for ammeters and voltmeters
GB/T 7676.2-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 2:Special requirements for ammeters and voltmeters
GB/T 7676.3-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 3:Special requirements for wattmeters and varmeters
GB/T 7676.3-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 3:Special requirements for wattmeters and varmeters
GB/T 7676.4-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 4:Special requirements for frequency meters
GB/T 7676.4-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 4:Special requirements for frequency meters
GB/T 7676.5-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 5:Special requirements for phase meters,power factor meters and synchroscopes
GB/T 7676.5-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 5:Special requirements for phase meters,power factor meters and synchroscopes
GB/T 7676.6-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 6:Special requirements for ohmmeters(impedance meters) and conductance meters
GB/T 7676.6-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 6:Special requirements for ohmmeters(impedance meters) and conductance meters
GB/T 7676.7-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 7:Special requirements for multi-function instruments
GB/T 7676.7-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 7:Special requirements for multi-function instruments
GB/T 7676.8-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 8:Special requirements for accessories
GB/T 7676.8-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 8:Special requirements for accessories
GB/T 7676.9-1998 Direct acting indicating analogue electrical measuring instruments and their accessories Part 9:Recommended test methods
GB/T 7676.9-2017 Direct acting indicating analogue electrical measuring instruments and their accessories—Part 9:Recommended test methods
GB/T 16895.4-1997 Electrical installations of buildings Part 5:Selection and erection of electrical equipment Chapter 53:Switchgear and control gear
GB 16895.12-2001 Electrical installations of buildings—Part 4:Protection for safety—Chapter 44:Protection against overvoltages—Section 443:Protection against overvoltages of atmospheric origin or due to switching
GB 16916.1-2003 Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses(RCCB)—Part 1:General rules
GB/T 16935.1-2008 Insulation coordination for equipment within low-voltage systems—Part 1:Principles,requirements and tests
GB/T 16935.3-2005 Insulation coordination for equipment within low-voltage systems—Part 3:Use of coating,potting or moulding for protection against pollution
GB/T 16935.3-2016 Insulation coordination for equipment within low-voltage systems— Part 3:Use of coating,potting or moulding for protection against pollution
GB/T 16935.3-2025 Insulation coordination for equipment within low-voltage systems—Part 3:Use of coating,potting or moulding for protection against pollution
GB/T 17626.2-1998 Electromagnetic compatibility—Testing and measurement techniques—Electrostatic discharge immunity test
GB/T 17626.2-2006 Electromagnetic compatibility—Testing and measurement techniques—Electrostatic discharge immunity test
GB/T 17626.2-2018 Electromagnetic compatibility—Testing and measurement techniques—Electrostatic discharge immunity test
GB/T 17626.3-1998 Electromagnetic compatibility—Testing and measurement techniques-Radiated, radio-frequency, electromagnetic field immunity test
GB/T 17626.3-2006 Electromagnetic compatibility—Testing and measurement techniques—Radiated, radio-frequency, electromagnetic field immunity test
GB/T 17626.3-2016 Electromagnetic compatibility—Testing and measurement techniques—Radiated,radio-frequency,electromagnetic field immunity test
GB/T 17626.3-2023 Electromagnetic compatibility—Testing and measurement techniques—Part 3:Radiated,radio-frequency,electromagnetic field immunity test
GB/T 17626.4-1998 Electromagnetic compatibility—Testing and measurement techniques—Electrical fast transient/burst immunity test
GB/T 17626.4-2008 Electromagnetic compatibility—Testing and measurement techniques—Electrical fast transient/burst immunity test
GB/T 17626.4-2018 Electromagnetic compatibility—Testing and measurement techniques—Electrical fast transient/burstimmunity test
GB/T 17626.5-1999 Electromagnetic compatibility—Testing and measurement techniques—Surge immunity test
GB/T 17626.5-2008 Electromagnetic compatibility—Testing and measurement techniques—Surge immunity test
GB/T 17626.5-2019 Electromagnetic compatibility—Testing and measurement techniques—Surge immunity test
GB/T 17626.6-1998 Electromagnetic compatibility—Testing and measurement techniques—Immunity to conducted disturbances, induced by radio-frequency fields
GB/T 17626.6-2008 Electromagnetic compatibility—Testing and measurement techniques—Immunity to conducted disturbances,induced by radio-frequency fields
GB/T 17626.6-2017 Electromagnetic compatibility—Testing and measurement techniques—Immunity to conducted disturbances,induced by radio-frequency fields
GB 18499-2001 Residual current operated protective devices(RCD) for household and similar use—Electromagnetic compatibility
GB/T 18499-2008 Residual current operated protective devices (RCD) for household and similar use—Electromagnetic compatibility
GB/T 18499-2025 Residual current-operated protective devices(RCD) for household and similar use—Electromagnetic compatibility
IEC 60050-101:1998
IEC 60417-2:1998
IEC 61557-8:1997
CISPR 14-1:2002
ISO/IEC指南 2:1991 标准化及相关活动的一般术语及其定义
Adopt standards
IEC 62020:2003
Related Standards
GB/T 13601-1992
Replaced
GB/T 13601-1992 Operating tests under severe ice conditions for high-voltage switchgear
GB 7674-1997
Replaced
GB 7674-1997 Gas-insulated metal-enclosed switchgear for rated voltages of 72.5 kV and above
GB 7251.1-1997
Replaced
GB 7251.1-1997 Low-voltage switchgear and control gear assemblies—Part 1:Type-tested and partially type-tested assemblies
GB 7251.3-1997
Replaced
GB 7251.3-1997 Low-voltage switchgear and control gear assemblies—Part 3:Particular requirements for low-voltage switchgear and control gear assemblies intended to be installed in places where unskilled persons have access for their use—Distribution boards
GB 14048.7-1998
Replaced