GB/T 26168.2-2018 Active National standards

GB/T 26168.2-2018 Electrical insulating materials—Determination of the effects of ionizing radiation—Part 2:Procedures for irradiation and test

Publish Date: 2018-06-07 Implement Date: 2019-01-01 For services related to genuine standard inquiry, procurement, translation, and other related services in China, please Contact Us

Basic Information

Standard Code: GB/T 26168.2-2018

Standard Type: National standards

Standard Status: Active

is_force_gb: no

CCS Name: Electrician's insulating materials and their products

ICS Name: Plastic and rubber insulation materials

Publish Date: 2018-06-07

Implement Date: 2019-01-01

Pages: 19 pages

Scope

This part of GB/T 26168 specifies the irradiation conditions that should be maintained before, during, and after irradiating insulating materials with ionizing radiation to determine whether radiation induces physical or chemical changes in their properties. It proposes several irradiation conditions that may have significant application value and lists various parameters that may affect radiation-induced reactions under these conditions. This part is applicable to the selection of samples, irradiation conditions, and test methods to facilitate the determination of the significance of radiation's impact on performance. Since many materials are used in air or inert gas environments, standard irradiation conditions are provided for these two scenarios. This part is not applicable to measurements during irradiation.

Development Information

Word Count: 34 Thousand words Pages: 19 pages

Same series standard

GB/T 26168.1-2018 Electrical insulating materials—Determination of the effects of ionizing radiation—Part 1:Radation interaction and dosimetry GB/T 26168.4-2018 Electrical insulating materials—Determination of the effects of ionizing radiation—Part 4:Procedures for assessment of ageing in service

Replace the following standards

GB/T 26168.2-2010 Electrical insulating materials—Determination of the effects of ionizing radiation—Part 2:Procedures for irradiation and test

Referenced Standards

IEC 60093 IEC 60167 IEC 60212 IEC 60243-1 IEC 60544-1 IEC 60544-4 ISO 37 ISO 48 ISO 178 ISO 179(所有部分) ISO 527(所有部分) ISO 815(所有部分) ISO 868

Adopt standards

IEC 60544-2:2012

Related Standards

GB/T 5130-1997 Replaced

GB/T 5130-1997 Test methods for industrial rigid laminated sheets based on thermosetting resins for electrical purpose

Publish Date: 1997-06-03

MT 756-1997 Abolished

MT 756-1997 Test method of flame resistance property of polystyrene foam plastics for water trough for explosion suppression

Publish Date: 1997-12-30

GB/T 7113-2003 Replaced

GB/T 7113-2003 Flexible insulating sleeving—Definitions and general requirements

Publish Date: 2003-06-24

GB 12802.2-2004 Replaced

GB 12802.2-2004 Film for electrical insulation—Part 2:Polythylene terephthalate film used for eletrical insulation

Publish Date: 2004-02-04

GB/T 20875.1-2007 Active

GB/T 20875.1-2007 Method of test for the hydrolytic stability of electrical insulating materials—Part 1:Plastic films

Publish Date: 2007-01-23

GB/T 23641-2009 Replaced

GB/T 23641-2009 Fiber reinforced unsaturated polyester moulding—compounds(SMC and BMC)for electrical purposes

Publish Date: 2009-04-21